Can you mount a 65-inch TV on a hollow drywall partition wall without studs?

Mounting a 25kg 65-inch TV directly onto hollow drywall without hitting any framing is technically possible with metal SnapToggles, but doing it purely on raw plasterboard carries long-term risks.The main issue is not the bolt itself. A single 1/4-inch metal TOGGLER SnapToggle can easily support over 40kg in sheer weight on standard drywall. The actual weak point is the plasterboard wall. Drywall is just compressed gypsum chalk sandwiched between paper. While it holds static weight fine when fresh, dynamic movement like plugging in HDMI cables, adjusting a tilting mount, or accidentally brushing against the edge of a 65-inch screen degrades the gypsum around the anchor over time. Eventually, the hole widens, the paper skin tears, and the anchor pulls through.In UAE residential properties, including those in Umm Al Quwain, partition walls are built over light-gauge galvanized steel frame studs spaced either 400mm or 600mm apart. If the center of your wall feels hollow, a stud is almost certainly sitting 15 to 30 centimeters to the left or right of your target spot.<b>How you handle this depends on your mounting position and the hardware you have. </b> If you can shift the TV bracket slightly, try to cross at least one metal stud. Catching a steel stud with two Tek screws (self-drilling metal screws) on one side of the wall plate and using two metal SnapToggles on the hollow side creates an extremely secure mount. The metal stud carries the weight, while the toggles keep the frame flat against the board.<b>If the TV must sit dead-center on a hollow section with zero studs lining up: </b> Use a wide, fixed or basic tilt bracket. Avoid full-motion or cantilever arms entirely. Extending a 25kg screen 40cm out from a hollow wall creates leverage that multiplies the pull-out force on the top anchors by three to four times, which will eventually rip out of raw drywall. Drill clean holes for the SnapToggles using a sharp bit. Avoid tearing the paper backing on the inside of the wall, as that paper skin provides most of the pull-out resistance for toggle bolts.Space at least four 1/4-inch metal SnapToggles as far apart as the bracket allows to spread the load across a wider surface area of the wallboard.If the drywall flexes when you push on it or feels noticeably thin, skip mounting directly to it. The safest fix is to mount a piece of 18mm plywood to the nearest metal studs behind the wall, paint it to match the room, and attach the TV bracket directly to the plywood. That transfers the entire 25kg load to the structural frame of the partition without risking the plasterboard.